M-4120 information

Carver Car Audio Discussions and Questions
Post Reply
killerb
Newbie
Posts: 3
Joined: Sat Sep 03, 2005 8:10 am

Post by killerb » Tue Jul 25, 2006 5:07 pm

it is a 4x120 into 4 ohms. it is bridgeable into 8 ohms making it only 4 ohm stable.

wire
Newbie 50+
Posts: 59
Joined: Fri Jan 21, 2005 7:32 pm

Post by wire » Wed Aug 16, 2006 8:02 pm

Frikkin Killer amp :) .

danw2002
Newbie
Posts: 45
Joined: Mon Dec 01, 2003 9:05 pm
Location: Seattle area
Contact:

Post by danw2002 » Mon Aug 28, 2006 2:00 pm

that was the big problem with these amps, they did not like running into 4ohms mono and installers where told to not do it, but did anyway and would blow the amp and then complain about the amp. they put out 240watts into 8 ohms bridged mono!! which was very good, gives much more cone control for that kind of power but still most installers did not 'get' it so they got a bit of a bad rap, to this day it is still my favorate series of amps(M2060, M4060, M2120, M4120, M240) and I still use them in my cars for all mid/tweets.
killerb wrote:it is a 4x120 into 4 ohms. it is bridgeable into 8 ohms making it only 4 ohm stable.
Dan Williams
carver nut,
who lives only
a few miles from
their old office....

Post Reply

Return to “Carver Car Audio”