he sent me a PM asking some questions, and i said to give me a call , as i did not have the info at my fingertips, but he has tried to call me but keeps missing me, so i dug up the info for all, soooo here ya go...for the M240, the M2120 is very close, although the crossover point may be lower....
Stereo mode....both switches out, RCA to Low in jack,left and right speakers to speaker out wires.
mono mode.....same but with mono switch in,mono speaker to
Left +/Rt.-using the Left + as speaker +, left input is the mono input...
Bi-amp mode.....bi-amp switch in ,this amp becomes the sub amp.can run in stereo or mono mode as above but output will only be 115 hz and below.
115 hz and above will come out of bi-amp RCA. this can then
go to an other amp as hi-pass input sig.
120 watts per channel into 4 ohms,20-20kHz,both channels driven,13.8volts
no more than 0.15%THD.240watts mono 20-20kHz no more than 0.15%THD.
S/n greater than 100dB.Subsonic filter at 15Hz.cross over 18dB/octave @115Hz
you can run 4 or 8 ohm load in mono ,I would be careful in a 4 ohm load of
high volumes......the amp puts out only 150 watts mono into a 4 ohm load
but 240 watts into a 8 ohm load, so not only do you get more power into 8
ohms but better control
danw2002 wrote:Paul, see my PM to you, i know all about this amp.